Free tool

Via current calculator

Estimate how much current a plated through-hole via can carry, its DC resistance and thermal resistance, and how many vias in parallel you need for a power connection. Everything runs in your browser.

Via geometry

copper barrel model

Typical barrel plating is specified as an average of 20 µm (IPC-6012 Class 2) or 25 µm (Class 3); check the value your fab guarantees. Resistance is evaluated at ambient + ΔT.

Formulas and assumptions

The barrel is modelled as a copper tube with finished (inner) diameter d and wall thickness t. If you enter the drill size, the finished hole is d = drill − 2t.

QuantityFormula
Barrel cross-sectionA = π · ((d/2 + t)² − (d/2)²)
Current estimateI = 0.048 · ΔT0.44 · A0.725 (A in mil², IPC-2221 external-layer fit)
DC resistanceR = ρ · L / A, ρ = 1.72 × 10⁻⁸ Ω·m · (1 + 0.00393 · (T − 20))
Thermal resistance of the barrelθ = L / (k · A), copper k ≈ 385 W/(m·K)
Vias neededN = ⌈Itarget / Ivia⌉

Validity and accuracy

  • IPC-2221 gives no formula for vias. Treating the barrel as an external track is a widespread, conservative estimate: a via is short and cooled by the pads and planes it connects, so it usually carries more than this before reaching the same rise.
  • The tracks or planes leading into the via are usually the real bottleneck. Size them with the trace width calculator.
  • Plating is thinner in the middle of high aspect ratio holes (above roughly 8:1 to 10:1), which raises resistance and lowers capacity.
  • Parallel vias share current well only when they are connected symmetrically. Spread them across the current path rather than in a single row.
  • Thermal resistance covers only conduction along the copper barrel; filled vias, pads, planes and the laminate around the hole add parallel heat paths that this model ignores.

FAQ

Why does doubling the hole size not double the current?

The current depends on the copper area of the barrel wall, which grows roughly with the circumference, and the IPC fit grows with area to the power 0.725. A larger hole helps, but more vias in parallel usually help more for the same board area.

Does a filled or capped via carry more current?

Conductive or copper fill adds cross-section and lowers thermal resistance; non-conductive (epoxy) fill adds almost nothing electrically. This calculator models the plated barrel only.

What plating thickness should I enter?

Use the minimum average your fab guarantees. 20 µm (Class 2) and 25 µm (Class 3) averages are common specifications; using the minimum keeps the estimate on the safe side.

How should I use the thermal resistance?

It tells you how well one via conducts heat from the top to the bottom of the board, for example under a power package. Vias in parallel divide it by their number.