Stack-up planner
Pick a layer count and board thickness and get a symmetric reference stack-up with layer roles, dielectric thicknesses and 50 Ω / 90 Ω / 100 Ω trace widths for every signal layer. Edit any layer and the checks update.
Everything is calculated in your browser: nothing is uploaded and your design data never leaves your machine.
Layers
Edit roles and dielectric thicknesses| Layer | Type | Role / material | Thickness (mm) | Copper / εr |
|---|
Trace widths
IPC-2141A closed-form estimates| Layer | Model | Reference | 50 Ω SE | 90 Ω diff | 100 Ω diff | Notes |
|---|
KiCad-style text summary (also copied by the button above)
How it works and assumptions
- Construction. Foil build: outer prepregs, then cores and prepregs alternating, so an N-layer board has N−1 dielectrics. The outer prepregs are kept thin (up to 0.2 mm) for tight microstrip coupling; the inner dielectrics share the remaining thickness, with a double share between two adjacent signal layers to space them apart. Any rounding remainder goes into the centre dielectric so the build stays symmetric.
- Layer roles. 4 layers: SIG / GND / PWR / SIG. 6 layers: SIG / GND / SIG / SIG / PWR / SIG, or SIG / GND / SIG / PWR / GND / SIG. 8 layers and up: every signal layer has an adjacent reference plane where the count allows. Both ground and power planes count as references.
- Thickness. Uses base copper (0.5 oz = 18 µm, 1 oz = 35 µm, 2 oz = 70 µm). Plating on outer layers, solder mask and pressed prepreg thickness after resin flow are not modelled, so the fab’s own build will differ slightly.
- Symmetry. Each layer is compared with its mirror about the centre. Different copper weights, a plane opposite a signal layer, or unequal dielectrics are flagged as bow-and-twist risks.
- Trace widths. Outer layers use the surface microstrip formula; inner layers between two planes use symmetric stripline. When the trace is off-centre the impedance is approximated as two symmetric striplines in parallel. An inner layer with only one plane is estimated with the microstrip formula and flagged. All formulas come from the same module as our impedance calculator.
These are planning numbers good to a few percent inside each formula’s range. For controlled-impedance work the fab confirms widths on its own laminate with a field solver, usually to ±10%.
FAQ
Why is the stack-up symmetric?
Copper and resin expand differently with heat. A board whose top half differs from its bottom half warps during lamination and reflow (bow and twist). Mirroring copper weights, plane positions and dielectrics keeps it flat.
Which εr should I use?
Standard FR-4 class materials are usually between 4.2 and 4.5 at 1 GHz, and prepreg is often a little lower than core because of its higher resin content. If your fab publishes a stack-up, use its values.
Is my stack-up uploaded anywhere?
No. The planner is plain JavaScript that runs in your browser. Nothing you enter is sent to our servers, and the CSV and text exports are generated locally.
Can I use the widths directly in my design rules?
Use them to set up net classes and routing early. Before release, ask your fab to confirm widths on their actual build, and order the board with impedance control if the tolerance matters.