Free tool

Trace width calculator

Size a power track from its current and allowed temperature rise with the classic IPC-2221 formula, check how much current an existing track can carry, and see its resistance, voltage drop and power loss. Everything runs in your browser.

Current and copper

IPC-2221 design-chart fit

Your track

reverse check and losses

Copper thickness is the nominal foil (1 oz = 34.8 µm = 1.37 mil). Outer layers are usually plated up, which adds copper; inner layers are not. Resistance is evaluated at ambient + ΔT.

Formulas and assumptions

IPC-2221 (Generic Standard on Printed Board Design, section 6.2) fits its conductor current charts with:

I = k · ΔT0.44 · A0.725  →  A = (I / (k · ΔT0.44))1/0.725

SymbolMeaning
ICurrent in amperes
ΔTTemperature rise above ambient in °C
ACopper cross-section in square mils (1 mil = 0.0254 mm)
k0.048 for external layers, 0.024 for internal layers
WidthA / thickness, with 1 oz/ft² = 34.8 µm = 1.37 mil

Resistance: R = ρ · L / (w · t) with copper resistivity ρ = 1.72 × 10⁻⁸ Ω·m at 20 °C, corrected by ρ(T) = ρ₂₀ · (1 + 0.00393 · (T − 20)). Voltage drop is I · R and power loss I² · R. The calculation treats the track as a rectangular bar at a uniform temperature and ignores etch trapezoid, plating, solder mask and nearby copper.

Validity and accuracy

  • The IPC-2221 charts cover up to 35 A, temperature rises of 10–100 °C, 0.5–3 oz copper and widths up to 400 mil (10.2 mm). Outside that range the calculator still shows a number but flags it as extrapolated.
  • IPC-2221 is the classic, conservative formula. Its internal-layer factor (half of external) is particularly pessimistic.
  • IPC-2152 (Standard for Determining Current Carrying Capacity in Printed Board Design) replaced the old charts with measured data that also accounts for board thickness, planes and board material. Its results are usually more accurate and, for internal layers, usually allow narrower tracks. Use IPC-2152 charts or a thermal simulation for tight designs.
  • Short tracks between large pads or pours run cooler than the formula suggests; long isolated tracks, enclosures and high ambient temperatures run hotter.

FAQ

What temperature rise should I choose?

10 °C is a common, comfortable default for general designs. 20–30 °C is often accepted for power tracks when the board material and nearby components tolerate it. Keep the ambient plus rise well below the glass transition temperature of the laminate and the ratings of nearby parts.

Why is the internal layer track so much wider?

IPC-2221 assumes inner layers shed heat half as well as outer layers, so k drops from 0.048 to 0.024. Measured data in IPC-2152 shows inner layers are often not that much worse, especially near planes, so this result is on the safe side.

Does the plating on outer layers count?

Outer layers usually receive extra copper during via plating, so a 1 oz outer layer often finishes thicker than 34.8 µm. The calculator uses the nominal foil weight, which errs on the conservative side. Ask your fab for the finished thickness if you need a tighter number.

Can I use this for AC or pulsed currents?

Use the RMS current for heating. For short pulses the copper's thermal mass helps, while at high frequencies skin effect raises the resistance; neither is modelled here.